Arturia Analog Factory 2.5 User's Manual de usuario descargar pdf (Pagina 32)

32 ARTURIA – MiniLab – USER’S MANUAL

The first press of Pad 6 will send a CC# 74 command with a value of 78, which will close

the filter down part way but still let a lot of the audio pass through. The second press of

Pad 6 will send a value of 127, opening the filter completely.

Note: Be sure to check the MIDI Channel assignment to make sure it matches that of the

receiving device.

5.1.5 Assign an Encoder to control a MIDI CC # between two values

The encoders are assignable using the same techniques described for the pads. Let’s

give a quick example of an interesting use: setting the rate of an LFO so it operates only

within a certain range.

Looking at the picture above we see familiar information:

 Encoder 5 has been selected, so it is shown in red.

 It is assigned to the Global MIDI channel; you can specify any MIDI channel from

1-16 or leave it on the Global channel.

 Its Mode is set to Continuous, which means it will transmit a MIDI Continuous

Controller number when it is turned.

 The second Mode field is set to Absolute, which means it will transmit in a linear

fashion from fully counter-clockwise to fully clockwise.

 The CC number field shows CC# 76, the MIDI CC # that has been assigned to

control Vibrato Rate.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 41 42

Sin comentarios

Arturia Analog Factory 2.5 User's Manual de usuario Pagina 32